How to add mod to fallout 41/5/2023 ![]() You need copper to make wires, even though it does not explicitly tell you this. To maximize the distance you get out of connectors, you can build the connector right next to the first object, and then move it to the maximum distance afterward. ![]() If the two things you want to connect are too far apart, you can build a connector in between and use two wires with the connector in the middle. I'm not certain if there's an absolute maximum length, but if the wire is stretched so far that the lowest part hits the ground, that's too far. While you are attempting to connect the wire to the second object, you will see a green or red wire hovering in the air. If the two objects are too far apart, you will not be able to connect them. On a large object, you may have to hunt around a little bit to find the right spot to connect to it. The option to do so should show up as you hover over the second object. Once you've attached the wire to one object, move over to the other object and attach the wire to it using the same button. You should see an option to "Attach Wire", and the corresponding mapped button. Instead, you get close enough to one of the objects you want to connect to interact with it (in workshop mode). ![]() There's no "wire" object to select from the build menus in the workshop.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |